How to convert campervan seating into a bed

After much pencil chewing and imaginary beard stroking over how to convert our campervan seating into a bed, Paul had an epiphany.

The first stage was fairly simple. By hinging an extra panel onto the long section of the L-shaped seating, we could pull it out to create the base of the bed. As shown here:


Paul had to cut the top panel marginally shorter than the bottom one, so it would clear the overhanging worksurface when pulled out. This will be hidden though once the seat cushions are on.

We’ve continued to use the same material for all the seating panels – I imagine the staff at Bunnings are somewhat intrigued by the sudden demand for their cheap pantry doors. It’s been a readily available form of MDF though with a glossy plastic coating, and has been really easy to work with.

The challenge was creating the supporting leg underneath the pull-out bed panel. The moment of revelation occurred when Paul worked out he could add another panel, which, when hinged, would act as a back rest in one position, and a supporting leg when folded down:

In the bed configuration, the two seat cushions will stay in position, and the two backrests will lie side by side on the other half. The bed is actually wider than I’d imagined; I was visualizing us both having to lie on our sides and turn over in unison, but it’s about 1.2m wide, which is fairly comfortable.

This week Paul has also fitted the master control switch, and bought the battery and the charger, so the next job is to start wiring everything up. Since winter arrived early in Brisbane, I have been lobbying for a nice warm fan heater, in case the van is finished before August. I’ve been advised to just rug up.